Heavy Duty differential covers and transmission pans supply increased lubricant and cooling capacity for hard working recreational and repair vehicles. Mag-Hytec covers and pans set your vehicle apart in both aesthetics and serve as – cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs lure worn gear subject matter promoting fluid integrity. Each and every unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 chrome steel, in such a lot applications no gasket or sealant is needed, and all Mag-Hytec portions are covered by an entire life limited warranty. Rely on Mag-Hytec if you end up pulling a heavy load.
Steer clear of costly reapirs – Extend the lifetime of your Vehicle – Expand oil Capacity – Runs Cooler, Lasts Longer
Average of double the fluid capacity
Ease of Service
The dipstick is knurled for speedy removal, the flat is marked low/prime to test lube level and a magnet, which acts as an open clear out is within the lower end. The MS 7/8 – 14 THD port is big enough to make use of for filling.
The magnet-filled drain plug is identical MS port because the dipstick. Both the dipstick and drain are O-ring sealed.
The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug.
The calibration plug is centered at the serial number plate and approximates the stock cover fill plug for factory fluid level.
The O-ring is snapped into the inverted “V” groove for a good seal with out gasket or silicone.
Plugs, cap screws and washers are chrome steel in such a lot applications.
Mag-Hytec manufactures the most efficient covers and pans to be had nowadays.
Overall height 4 1/8″
Includes: Bolt kit, Drain Plug and Dip Stick.
Capacity: 6 Quarts