Heavy Duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and repair vehicles. Mag-Hytec covers and pans set your vehicle apart in both aesthetics and serve as – cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear subject matter promoting fluid integrity. Every unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless-steel, in so much applications no gasket or sealant is needed, and all Mag-Hytec parts are covered by a life-time limited warranty. Rely on Mag-Hytec if you find yourself pulling a heavy load.
Keep away from costly reapirs – Extend the lifetime of your Vehicle – Expand oil Capacity – Runs Cooler, Lasts Longer
Average of double the fluid capacity
Ease of Service
The dipstick is knurled for speedy removal, the flat is marked low/high to test lube level and a magnet, which acts as an open clear out is within the lower end. The MS 7/8 – 14 THD port is big enough to make use of for filling.
The magnet-filled drain plug is identical MS port because the dipstick. Both the dipstick and drain are O-ring sealed.
The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug.
The calibration plug is centered at the serial number plate and approximates the stock cover fill plug for factory fluid level.
The O-ring is snapped into the inverted “V” groove for a good seal with out gasket or silicone.
Plugs, cap screws and washers are stainless-steel in so much applications.
Mag-Hytec manufactures the most productive covers and pans to be had these days.
Overall height 3 1/2″ Capacity: 6 Quarts
Includes: Bolt kit, Drain Plug and Dip Stick.
Should check to ensure Full Floating Axle
Ring gear on passengers side of center
6 Liter Gas 2500 HD Should Visually make sure, a few have #GM 14-9.5